Buhler 2425 User Manual
Page 206
SECTION 2 - OPERATION
2-148
9. If the measurement is not within specs,
loosen the feedback potentiometer cover
screws, 1.
10. Adjust the potentiometer by rotating the
potentiometer cover plate tab, 2, CW to raise
the hitch and CCW to lower the three-point
hitch.
11. Tighten the adjustment screws and repeat
the measuring procedures as detailed in
steps 2 through 8.
12. A final quick check for the proper adjustment
is to lift the three-point hitch in the automatic
mode. Switch to the manual mode and
depress in the raise position. The lift cylinder
should extend approximately 6mm (1/4″)
upward from the full automatic raise position.
IMPORTANT: In the automatic raise mode,
the three-point hitch must automatically stop
raising before the cylinders are fully
extended.
2
1
Figure 2-214