Buhler 2425 - Manual (Page 74)

SECTION 2 - OPERATION
2-16
Figure 2-24
11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10
Warning Light Bar
The warning light bar provides visual indication
of specific functions as follows:
1 Left Turn Signal and Flasher Indication
Arrow - illuminates when the multifunction
switch is placed in the left turn position
(flashes), when the multifunction switch is
placed in the right turn position (steady) and
when the rotary light switch is in positions two
or three (flashes).
2 High Beams - illuminates when the
multifunction switch is pulled toward the
steering column for headlight flash or high
beam position.
3 Air Filter Restriction - illuminates when there
is 635 mm (25″) of H
2
O vacuum being
caused by a restriction in the engine air filter
assembly.
4 Park Brake - illuminates when the park brake
handle is pulled upward in the lock position
and goes out when the park brake is in the
downward (operate) position.
5 Safety Belt - illuminates when the ignition
switch is turned to the “RUN” position and
stays illuminated for five seconds to remind
the operator to fasten the safety belt. The
light will then go out and will not re-light until
the ignition switch is turned off and then
turned back to the run position.
6 Low Fuel Level - illuminates when the fuel in
the tanks is at 1/12 or less capacity (1/12
equals 68.1 L or 18 US gals).
7 PTO Switch - illuminates when the PTO
switch is placed in the “ON” position and
power is supplied to the circuit supplying the
PTO solenoid.
8 Alternator Output - illuminates when the
alternator has stopped sending a charging
output to the electrical system.
9 Front Differential Lock - illuminates when the
differential lock switch is placed in the “ON”
position. The light goes off when the
differential lock switch is placed in the “OFF”
position or when the brake is depressed.
10 Right Turn Signal and Flasher Indication
Arrow - illuminates when the multifunction
switch is placed in the right turn position
(flashes), when the multifunction switch is
placed in the left turn position (steady) and
when the rotary light switch is in positions two
or three (flashes).
11 Engine Coolant Level - illuminates when the
engine coolant in the radiator has dropped
4.5 L (5.3 US qts.) below the acceptable fill
level in the radiator.
12 Red Engine Coolant Temperature -
illuminates when the engine coolant
temperature reaches 109°C (228°F),
indicating engine overheating requiring
shutdown.
13 Not used.
14 Engine Oil Pressure - illuminates when the
engine oil pressure reaches 100 kPa (15
PSI), indicating the engine oil pressure has
reached a point unacceptable for proper
engine lubrication.