Buhler 2425 - Manual (Page 292)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-68
AS REQUIRED
OPERATION 63
Change the Roof Warning Light Bulbs
To change a bulb on the roof-mounted hazard
lights, remove the two screws, 1, from the light
lens and remove the lens.
Figure 3-109
1
Unscrew the bulb, 1, from the light socket and
replace it with a new bulb. Reassemble the lens
to the roof using the two screws.
Replacement bulbs can be purchased from your
Buhler Versatile dealer.
Figure 3-110
1
OPERATION 64
Change the Brake Light Bulbs
To replace a bulb in the rear fender-mounted
brake lights, remove the two mounting screws, 1,
on the lens of the light. First, remove the nuts on
the underside of the fender which retain the
shield, 2. Then the screws, 1, can be removed,
allowing access to the bulb, 3.
Unscrew the bulb from the socket and install a
new bulb. Reinstall the lens onto the light socket.
Slide the light into the fender and install a washer
and nut on each screw; tighten securely.
Properly position the wire harness shield back
into place making sure the shield hooks into the
support strap that is under the rear fender-
mounted work lamps. Install a washer and nut on
each screw; tighten securely
Replacement bulbs can be purchased from your
Buhler Versatile dealer.
Figure 3-111
1
3
2