Buhler 2425 - Manual (Page 151)

SECTION 2 - OPERATION
2-93
The module will illuminate the appropriate
engine warning light (yellow or red) based on the
source of the fault, and will take additional action
by adjusting the performance of the engine by
one of following methods:
-- Illuminate engine warning light only, no
performance modification
-- Illuminate engine warning light, perform
speed derate only
-- Illuminate engine warning light, perform
power derate only
-- Illuminate engine warning light, perform
speed and power derate
The appropriate engine warning light will remain
illuminated and the performance derate will
remain in effect until the system fault is
corrected. The Operator cannot cancel or
interrupt the derate sequence from occurring on
the engine. The module does not recognize
activation of nor is it tied into the EICS
acknowledge/reset button on the dash of the
tractor.
If the tractor is shut down and then restarted,
and the electrical fault still exists on the tractor
(non--critical or critical), the module will repeat
the warning light and derate sequence. If the
tractor is restarted and the fault has been
corrected, the tractor will return to normal
operation. If the tractor is not shut down, and the
alarm condition is corrected, the tractor will
return to normal operation without having to
shut it off and restart it.
Important: Whenever an engine warning light
(yellow or red) is illuminated on the EICS of the
tractor shut the tractor down and contact your
Buhler Versatile Dealer to investigate the cause
of the concern. Your Buhler Versatile Dealer will
coordinate the repair of the engine via an
authorized Cummins Engine Company
dealer/distributor.