Buhler 2425 - Manual (Page 129)

SECTION 2 - OPERATION
2-71
9. Setting the Engine Flywheel Ring Gear
Profile
NOTE: This value is set when the machine
is built. It does not require operator setup,
and should never be changed.
Instructions are provided here only in the
event the value was inadvertently
changed.
A. The upper portion of the monitor will flash
“ENG” and “SET” with “SETUP”
displayed. The lower portion of the display
will show 103 or 12, depending on current
programmed selection.
B. Use the following chart to determine
which “ENG” number should be
programmed into the EIC:
Model
Number Engine
“ENG”
Number
2290, 2335,
2375
QSM11 12
2360, 2425 N14 103
C. To place the correct value into the monitor,
use the digit select switch. Move the
switch up for 103, or down for 12.
D. Press the Acknowledge/Reset button to
enter the value into the monitor’s memory.
The display will now return to “Setting the
Final Drive Ratio.”
All possible programming for the hours
position is now complete. If no further
calibration is needed, turn the ignition to
the “OFF” position.
Figure 2-103
12
Figure 2-104