Buhler 2425 - Manual (Page 242)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-17
EVERY 10 HOURS OR DAILY
2360 and 2425 (N14) Engine
Loosen the compressor pivot bolt located behind
the compressor next to the engine block. Loosen
the adjuster clamp bolt, 1, and adjustment
locknut, 2. Tighten the adjuster bolt, 3, to
increase belt tension. Tighten the adjuster clamp
bolt, 1, locknut, 2, and pivot bolt after the correct
belt tension is obtained. Recheck the belt tension
once all hardware is tightened. Torque the pivot
bolt and adjuster clamp bolt to 79 N⋅m (58 ft. lbs.),
and the locknut to 61 N⋅m (45 ft. lbs.).
IMPORTANT: Do not adjust belt tension to full
value with the adjusting screw. Belt tension can
increase when the locknut is tightened and,
therefore, reduce belt and bearing life.
If the belt requires replacement, the adjustment
should be backed off all the way, and the belt
slipped up around the pulleys. Install the new belt
by reversing the procedure and tension it as
detailed above. Never pry a belt off or on a pulley
as damage to the pulley and belt may result.
NOTE: The air-conditioning compressor
drive belt is supplied by Buhler Versatile.
Contact your Buhler Versatile dealer to
obtain a new belt.
Figure 3-17
1
3
2