Buhler 2425 - Manual (Page 115)

SECTION 2 - OPERATION
2-57
NOTE: The Electronic Instrument Control
System has a feature to alert the operator
of tractor ground speeds over 20 km/h
(12.5 MPH). If at any time the tractor
ground speed reaches 20 km/h (12.5
MPH), the lower portion of the monitor will
display the ground speed and MPH or
km/h symbol no matter which position the
rotary select switch is in.
Figure 2-86
The operator can switch the lower portion
of the monitor back to its former display by
pressing the acknowledge/reset button.
The former readout will return to the
monitor and the symbol “km/h” or “MPH”
will flash to remind the operator that the
tractor is traveling at a speed of 20 km/h
(12.5 MPH) or greater.
Figure 2-87
Service Interval One - The purpose of the
service interval one position is to allow the
user to preprogram the hour value to perform
a specific tractor service. An example of this
would be a 50-hour lubrication service. The
user can preprogram the monitor alarm to
indicate that 50 hours have been
accumulated on the tractor and lubrication is
required. Any value above ten hours can be
selected and programmed into the monitor
(see “Calibrating the Electronic Instrument
Control System” later in this section for
information on how to program the service
interval one setting).
Usually the service interval one position is
used for low-hour lubrication checks.