Buhler 2425 - Manual (Page 269)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-44
EVERY 500 HOURS
OPERATION 38
Check the Starter Battery Connections
Check to be sure that the battery cable
connection, 1, and the ground connection, 2, are
tight and clean where they attach to the engine
starter. Clean and tighten as necessary.
The starter is located on the left side of the
engine.
WARNING: DISCONNECT THE BATTERY
CABLES AT THE BATTERY BEFORE
WORKING ON THE BATTERY CABLE
CONNECTIONS AT THE STARTER.
Figure 3-59
1
2
OPERATION 39
Clean the Engine Air Precleaner
The engine air precleaner must be checked to be
sure that debris is not causing any obstruction at
the precleaner inlet.
To inspect the inlet to the precleaner, loosen the
hose clamp, 1, attaching the air cleaner tube, 2,
to the rubber boot, 3. Loosen the hose clamp, 4,
attaching the boot to the precleaner, 5.
(2360 - 2425 models illustrated).
Figure 3-60
4
1
3
2
5