INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 176)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 5.XX e page 174 of 276 ^
Example 1: Entering a very simple I/O program.
The following screen sequence illustrates the programming of the first I/O program introduced in Section 2
under the heading of I/O Programming Introduction. See page 41. To reiterate, the I/O program is as
follows:
001:
I71 T67
002:
END
Navigational path is: fixed front panel MENU key, EXECUTIVE MENU key and I/O SETUP key.
The result is the first screen below. This screen depiction assumes that there is no I/O program already
written in the A memory. If there is, switch to the B memory. Memory areas are selected by pressing the
SwaP key which appears after pressing the MEM key on the first screen shown below. Note that ID# starts
with either an A or B designating the memory shown. Use ED
I T/DEL to delete rungs (steps) until empty.
Make sure the factory I/O program has been saved first. There will be a need for it later.
I/O program has only END line. Press EDiT key. Result of pressing EDiT. Press INSert key*.
Result of pressing INSert. Press ChanGe key. Result of pressing ChanGe key. Press IN key.
Result of pressing IN. Enter 71 by pressing the 10 key 7 times and 1 key once. Result is shown above.
Result of pressing ENTer key. Press MORe key. Result of pressing MORe. Press MORe again.
Press MORe again. Note menu selection changes and numeric changes on MORe key. Press MORe again.
Press TriP key. Result of pressing TriP. Enter 67: press 10 six times,