INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 59)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 3.XX e page 57 of 276 ^
0.0 A/S 0.0 %PWR 0.000 KA
Review FILM# Review SS Map #
Review PROCESSES NEXT ACTIVE PROCESS
SERVICE Menu EXECUTIVE MENU
Review Film#:
(See Sect. 2.4,2.5 )
Review or edit film
parameters of user
specified film.
Only the main
menu screen has
these RunTime
values displayed
at the top.
All other menu
screens have path
information on
the 1
st line.
Press fixed
STATUS key for
Run Time Screen
Active Process:
(See Sect. 2.19, 2.7 )
Set active process to
user specified process.
Active Film:
(See Sect. 2.20 )
Set active film to user
specified film number.
0.0 A/S 0.0 %PWR 0.000 KA
Review FILM# REVIEW SS MAP #
SERVICE Menu
NEXT ACTIVE FILM EXECUTIVE MENU
OPT/INF MAIN / EXECUTIVE MENU
System configuration
I/O Setup Process accounting
Communications setup
Review SS Map:
Source Sensor (See Sect. X)
Review Processes:
(See Sect. 2.5,2.6 )
Review or edit
process to be
specified by user.
Communications setup:
(See Sect. 6.5 )
User specifies: Com I/O
lock code, keybd. beep,
RS232 baud and protocol.
System configuration:
(See Sect. 2.14, 2.13 )
User specifies: shutter
delay enable, 2 sensor
enable, rate sample
enable, LCD contrast,
password lock#, run#,
recorder fnct, clock t&d,
deployment of sensor
cards and I/O cards.
Process accounting:
(See Sect. 2.18 )
View process history
accounting screen.
I/O setup:
(See Sect. 5.1 )
View, scroll I/O rungs. View
operations status (run/stop)
and I.D.#. Further select:
Operations, Edit rung (line)
and Memory.
I/O setup; Operations:
(See sects. 5.9, 5.20 )
User selects operations mode:
run or stop or bak.
I/O setup; memory:
(See sects. 5.10, 5.20 )
User selects memory mode:
save, swap or bak.
I/O setup; Edit:
(See sects. 5.11, 5.12, 5.13, and
5.20 )
User edits selected line/rung using
arrow keys or GOTO. Insert / delete
rung line, and change rung.
on Run Time Screen (press fixed MENU key).
SQ/non-SQ. (S2.4)
factory settings.
purge stored data.
TEST mode. (S2.7)
I/O setup; Change:
Build/edit rung with command and
logical operator keys. Edit with
undo, delete last character.
Opt/Inf: (See Sect.2.21)
Reports on installed
internal and external
options and reports info
about versions, serial #s,
checksums, build codes,
error codes, etc.
STC-2002 MENU TREE (process sequencing)
(non-SEQ differences only)
[boxes not meant to be true LCD depictions]
Figure- 3.4: Menu Tree