INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 63)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 3.XX e page 61 of 276 ^
Choice: Next Process
NEXT ACTIVE PROCESS - This key choice allows the user to change the active process. There is
storage in the STC-2002 for 9 different processes. (See Sections x.x, x.x and x.x) (figure x.x).
The box containing the text NEXT PROCESS is a key used to indirectly input a new active process
number. Pressing the NEXT PROCESS key invokes the following display. Note on the main menu
display above that the active process number specified is 1. To select a different active process,
press the NEXT PROCESS key. When the numeric entry screen appears, enter the active process
number needed by pressing the digit key that represents the desired number and press ENTer to
accept or BAcK to discard. The number last entered immediately becomes the specified active
process. At times during certain phases of normal product use, the number digit will be
temporarily replaced with the text NA (not applicable) indicating that it would not be desirable to
change the ACTIVE PROCESS at a time when it is running. Also, NA appears when beginning
with a memory purged unit. The active process is the process that will begin with the next start. To
change an active process, the STC-2002 must be reset to the PROCESS STOP condition (Any
error condition must be cleared and no process can be running). See Sections 3.6-x3.7x for full
description.
Choice: Review Processes
REVIEW PROCESSES - This choice allows the product user to review and edit the process layer list
(recipe) of the selected process (1 through 9). Select the process number by pressing the REVIEW
PROCESSES key (See Sections x.x and x.x). The process that was last edited is shown in the
menu path (top line). associated digit key (see section 3.x). Pressing the REVIEW PROCESSES
key invokes the 1
st of the following 2 displays. To select a process for edit/review, press the GO2
PRC key. When the numeric entry screen appears, enter the number of the process to be
edited/reviewed by pressing the digit key that represents the desired number and press ENTer to
accept or BAcK to discard. Note that the process you are editing does not have to be the active
process. The active process is indicated by a "+" on the menu path line of the REVIEW
PROCESS menu.
Choice: Executive Menu
EXECUTIVE MENU - Changes how the STC-2002 is configured (communications, system configuration
and I/O setups) and allows access to Process Accounting screen and OPTions/INFo. (See Section
x.x ). A menu as shown in Figure 3.16 will appear. These are mainly system operations that
involve setups/configurations that are infrequently used. I/O setup is described in Section x,
Communications Setup and computer interfacing in Section x, Process Accounting in Section x.x,
and System Configuration/Communications setup in Section x.x. OPTions/INFo is described in
section x.x.