INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 95)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 3.XX e page 93 of 276 ^
Processes: Factory settings vs. purged settings.
The following example LCD displays show the difference between factory settings and purged settings for
PROCESS# 2. The first screen is the factory setting and has, for step 01, MODE=AUTO, FILM#=2, and
THICK(KA)=0.200. The second screen is the purged setting and has only the END line.
Typical Factory Setting Purged Setting
Factory (defaulted) Settings table for All Process Numbers:
Proc# 1 Proc#2 Proc#3 Proc# 4 Proc#5 Proc#6 Proc#7 Proc#8 Proc#9
STEP 01 01 01 01 01 01 01 01 01
MODE AUTO AUTO AUTO AUTO AUTO AUTO AUTO AUTO AUTO
FILM#
1 2 3 4 5 6 7 8 9
THICK 0.100 0.200 0.300 0.400 0.500 0.600 0.700 0.800 0.900
All factory Processes have END as STEP 02.
To restore factory settings or to purge settings, press the SERVICE key on the MAIN menu. This brings
forth the SERVICE menu as shown below.
Caution
Press the AS IS key once for PURGED, twice for FACTORY, thrice to return to AS IS.
[See section x3.21, Check sum validation. See section x7.3, battery and memory loss.]
Press the ACCEPT (/ restart) key to accept the configuration as described by all of the key labels. This will
also cause the unit to REBOOT with the new configuration in effect. Please see the section describing the
SERVICE menu as there are groups of settings other than those which are PROCESS# related (Film
parameters, I/O programs, etc.) that will be included in this configuration. Valuable process
programming could be lost. No I/O programs are factory restored because of the danger involved. Purge
will, however, clear I/O programs. See section x5.15 (table 5.4) for I/O program entry.
Press BYE to leave the SERVICE menu without accepting anything changed.
If the password is forgotten and programming has not been saved in some
other media, call factory to eliminate passwords without purging memory.
SECTION 3.7 Set Active Process
General
Description: (See Section moved here 2.9 and figure 2.12) To change the active
process (only allowed when the instrument is in IDLE and the LAYER value is "#" indicating an at rest
condition [observe the runtime screen]), press the fixed MENU key, which will produce the MAIN menu
Please be aware that changing the
memory contents by this means changes
more than just the process values. See
section X for a complete description.