MTS Series 793 Application - Manual (Page 167)

Set Process Parameters in the Procedure Table
MTS MultiPurpose TestWare® Creating a Practice Test Procedure 167
2. Define the Cyclic Command (Fatigue Part) process.
A. In the procedure table, click the Cyclic Command (Fatigue Part)
process icon.
B. In the Cyclic Command parameters pane, click the Channels tab.
Move all the channels you want to generate the command on to the
Included list. Move all the others to the Available list.
C. Click the Command tab. Type and select the parameters needed for the
test, as shown:
• Segment Shape: True Sine, at a Frequency of 1.00 Hertz.
• Count (enabled): 100 Cycles
• Channel: 10kN Actuator
• Control Mode: Force
• Absolute End Level 1: 4000 N
• Absolute End Level 2: 2000 N
D. Click the General tab and type information as desired.
Cyclic Command
(Fatigue Part)