MTS Series 793 Application - Manual (Page 386)

MTS MultiPurpose TestWare®
Failure Detector Process
Event Process Descriptions 386
11. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
12. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
13. In the Execute Process box, type number of times you want the process to
run.
14. Optional—In the Counter Type list, click a counter type.
15. Optional—If you enabled a counter, type a Counter Label.
16. Set the desired Start and Interrupt signals for the process in the procedure
table.