MTS Series 793 Application User Manual
Page 183
Segment Command Process
MTS MultiPurpose TestWare®
Command Processes
183
Channels tab
Displays the channels available to this process. Use the arrow keys to move
desired channels from the Available list to the Included list.
General tab
For more information
Control Mode
Specifies the control mode or control-mode variable.
Absolute End Level/
Relative End Level
Defines the segment end level:
•
Absolute End Level is relative to setpoint.
•
Relative End Level is relative to the starting command value (the value
when the process begins).
Command Tab (part 2 of 2)
I
TEM
D
ESCRIPTION
General Tab
I
TEM
D
ESCRIPTION
Name
Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled
Enables the process. (Clear this box to disable the process.)
Execute Process
Specifies the number of times the process will be run.
Counter Type
Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label
Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note
If this box is blank, the process name is used as the counter label.