MTS Series 793 Application User Manual
Page 223
Sweep Command Process
MTS MultiPurpose TestWare®
Command Processes
223
General tab
Channels tab
Displays the channels available to this process. Use the arrow keys to move
desired channels from the Available list to the Included list.
For more information
Absolute End Level
2/Relative End
Level 2
Defines the second end level value for the second segment in the channel.
Phase Lag
Specifies the phase relationship of the waveform generated by this process
from channel to channel. Phase Lag is disabled if Rate is specified for the
process.
Note
Phase Lag is relative to the channel that has the smallest degree of
phase. The Phase Lag of each channel is referenced to the lowest
Phase Lag defined in the channels.
Command Tab (part 2 of 2)
I
TEM
D
ESCRIPTION
General Tab
I
TEM
D
ESCRIPTION
Name
Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled
Enables the process. (Clear this box to disable the process.)
Execute Process
Specifies the number of times the process will be run.
Counter Type
Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label
Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note
If this box is blank, the process name is used as the counter label.