MTS Series 793 Application - Manual (Page 309)

High Speed Timed Acquisition Process
MTS MultiPurpose TestWare® Data Acquisition Process Descriptions 309
5. In the Sample Duration box, specify the length of time you wish the system
to acquire data. Or, select Total Samples, and specify the number of
samples you wish the system to acquire.
6. Click the Signals tab.
7. Move all the signals you want to monitor to the Included list. Move all the
others to the Available list.
Note The order of the signals in the Included list determines the order of the
columns of data in your data file.
8. Click the Destination tab.
9. Type the Buffer Size and type a description of the data file in the Data
Header box.
10. In the Destination list, click the destination for the acquired data. (If you
click User-specified data file, type a file name in the User Data File box.)
11. In the Buffer Type list, click the buffer type.
12. Optional—If desired, enable Write First Data Header Only checkbox.
This feature aids data sorting and analysis.
13. Optional—Click the Output Units tab.
Change the unit assignment set if you want. Each data acquisition process
can use a different unit assignment set.
14. Click the General tab.
15. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
16. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
17. In the Execute Process box, type the number of times you want the process
to run.
18. Optional—In the Counter Type list, click a counter type.
19. Optional—If you enabled a counter, type a Counter Label.
20. Set the desired Start and Interrupt signals for the process in the procedure
table.
For more information
See “Data Destination” on page 275.