MTS Series 793 Application - Manual (Page 427)

Send Mail Process
MTS MultiPurpose TestWare® Other Process Descriptions 427
Servers tab Configure server settings on this tab. You may need to contact your network
administrator or IT department to configure this tab.
General tab
Servers Tab
I TEM D ESCRIPTION
Maximum Wait Time Define the maximum time the process will wait for the server to respond without
producing an error (maximum of 60 seconds).
Server Name Select a server from the list. You can also edit the server display name in this field.
Add Click to add a new server.
Delete Click to delete the server displayed.
SMTP Server Enter the Simple Mail Transfer Protocol name or server IP address.
Return e-mail Enter the address that will appear in the “From” field of the generated message. This
must be a valid e-mail address permitted by your SMTP server.
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed in the Procedure or Group process window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only when the
process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the MPT
control panel.
Note If this box is blank, the process name is used as the counter label.