MTS Series 793 Application - Manual (Page 240)

MTS MultiPurpose TestWare®
Profile with ALC Process
Command Processes 240
9. For each station channel, select a Control Mode and optionally, a Level
Multiplier, and Level Reference.
10. Click the Command tab.
11. In the Adaptive Compensators list, select the ALC compensator.
12. Optional—click the Actions tab, and map station actions to profile actions.
13. Click the File Summary tab and verify your channel settings.
14. Click the Matrix tab and type a Compensation Matrix Name.
15. Optional—Select the Enable Frequency Compensation check box.
16. Under Verify Loaded Matrix Parameters, select whether or not you want
the application to verify the loaded matrix parameters.
17. Under Matrix Parameters, configure your ALC matrix.
18. Optional—If you want the matrix to be saved, select the Time Between
Matrix Saves check box, and then type a save interval.
19. Click the Tracking tab.
20. Set the units and type a value for the Missed Peak Reference for each
channel.
21. Click the General tab.
22. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
23. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
24. In the Execute Process box, type the number of times you want the process
to run.
25. Optional—In the Counter Type list, click a counter type.
26. Optional—If you enabled a counter, type a Counter Label.
27. Set the desired Start and Interrupt signals for the process in the group or
procedure table.