MTS Series 793 Application - Manual (Page 64)

MTS MultiPurpose TestWare®
MPT Options Editor Execution Tab
MPT Options Editor 64
Required Power Specifies the hydraulic pressure setting required by the control channels in
a procedure to start and continue running.
Note Power status applies only to control channels. If a procedure does
not contain control channels, the power status has no effect on
the procedure. For instance, if a procedure without control
channels has a power status of High and hydraulic power is
removed from the station, the procedure is still valid.
The selections are High, High/Low, Off, and Off/Interlocked.
The High selection applies to most testing situations; it requires you to
operate MPT with high hydraulic pressure applied to the station’s
Hydraulic Service Manifolds (HSM).
The Off and Off/Interlocked selections are typically used while you are
learning the application software or running test simulations.
Off/Interlocked disregards active interlocks for the sake of allowing you
to run the test unhindered.
Command Hold Behavior Specifies how command processes behave when the procedure transitions
to the hold state.
Command Stop Behavior Specifies how command processes behave when the procedure transitions
to the stop state.
Setpoint Enables or disables the Station Manager application’s Setpoint control on
the Setpoint and Span window.
Enable—Allows the operator to change the Setpoint slider on the
Setpoint and Span window while the test is running.
Note The Disable and Reset option does not apply to the External
Command process.
Disable and Reset—Prevents the operator from changing the Setpoint
slider on the Setpoint and Span window while the test is running.
Execution Tab (part 2 of 3)
I TEM D ESCRIPTION