MTS Series 793 Application - Manual (Page 230)

MTS MultiPurpose TestWare®
Signal Based Command Process
Command Processes 230
Mapping tab The Mapping tab allows you to specify SBC parameters for each control channel.
File Summary tab Displays a summary of the lookup-table file selected in the Command tab.
Click View to view and/or edit the lookup-table file in a text viewer.
The summary includes:
• The names of each lookup table defined in the lookup-table file.
• Lookup and Command units.
• The number of data points defined in each lookup table.
Mapping Tab
I TEM D ESCRIPTION
Lookup Table Use the Lookup Table list to specify the lookup table that will supply the
command for that channel. The names that appear in the Lookup Table list are
defined in the Table(x)=table name heading associated with each lookup table.
A lookup table appears in a channel Lookup Table list if the following is true:
• That channel includes a control mode that uses the same units defined in the
lookup table’s Command column.
• The station configuration contains at least one signal that uses the same units
defined in the lookup table’s Lookup column.
Note Click the File Summary tab for a listing of each lookup table defined in the
lookup-table file.
Lookup Signal Use the Lookup Signal list to define the signal used by the selected lookup table.
This signal’s units must match the signal units defined in the lookup table.
Control Mode Defines the control mode used for the channel.