MTS Series 793 Application - Manual (Page 403)

Program Control Process
MTS MultiPurpose TestWare® Other Process Descriptions 403
General tab
For more information
For more information on Actions, see “How to Use Actions with Processes” on
page 347.
Message Defines the content of the message written to the log.
Include Counters * Includes counter information with the message written to the message log.
Note This option can be used to periodically log counter information.
* If the Program Control process is configured to include counters and log on a transition state change,
your log will contain two similar messages each time the state changes. This occurs because all
state transitions are automatically logged with counter information. Keep in mind that the automatic
logs are displayed as Information, while the Program Control logs are displayed in the severity level
you specify (Information, Warning, Error, or Diagnostic). This allows you discern between these log
entries if desired.
Action Tab (part 3 of 3)
I TEM D ESCRIPTION
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.