MTS Series 793 Application - Manual (Page 246)

MTS MultiPurpose TestWare®
Cyclic with ALC Process
Command Processes 246
20. Under Matrix Parameters, configure your ALC matrix.
21. Optional—If you want the matrix to be saved, select the Time Between
Matrix Saves check box, and then type a save interval.
22. Click the Tracking tab and type a Missed Peak Reference amount and
corresponding units.
23. Click the General tab.
24. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
25. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
26. In the Execute Process box, type the number of times you want the process
to run.
27. Optional—In the Counter Type list, click a counter type.
28. Optional—If you enabled a counter, type a Counter Label.
29. Set the desired Start and Interrupt signals for the process in the group or
procedure table.