MTS Series 793 Application - Manual (Page 65)

MPT Options Editor Execution Tab
MTS MultiPurpose TestWare® MPT Options Editor 65
For more information
For more information, see “MPT Run/Stop/Hold Panel” on page 35.
For additional information about Command Stop Behavior, see “About
Command Hold and Stop Behaviors” on page 67.
For more information, see “About Setpoint Use with MPT Test Procedures” on
page 66.
Span Enables or disables the Station Manager application’s Span slider on the
Setpoint and Span window and the Master Span slider on the Station
Controls panel.
Enable—Allows the Span and Master Span sliders to affect the test
procedure command.
Note The Disable and Reset option does not apply to the External
Command process.
Disable and Reset—Prevents the Span and Master Span sliders from
affecting the test procedure command. The procedure plays out at 100%
span.
Confirm actions that may
affect resuming the test Enables or disables this confirmation function.
When enabled (as indicated by a check mark in the box), this function
causes query windows to pop up. The intent of these windows is to point
out the potential loss of data and stimulate additional thought about the
possible effects of your actions.
An example of a query message is as follows:
“Reset will discard test progress in the current specimen. Do you really
want to reset?”
Execution Tab (part 3 of 3)
I TEM D ESCRIPTION