MTS Series 793 Application - Manual (Page 392)

MTS MultiPurpose TestWare®
Digital Output Process
External Control Process Descriptions 392
How to Define a Digital Output Process
1. Drag the icon from the Process Palette to your procedure table.
2. Click the process icon in your procedure table or in the navigation pane.
3. Click the Outputs tab.
4. Move all the signals you want to send digital signals to the Included list.
Move all the others to the Available list.
5. Click the Output Table tab.
6. Select an option for each digital output signal listed.
Note If you select Pulse for any signal, you must specify a Pulse Width on the
Settings tab.
7. Click the General tab.
8. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
9. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
10. In the Execute Process box, type number of times you want the process to
run.
11. Optional—In the Counter Type list, click a counter type.
12. Optional—If you enabled a counter, type a Counter Label.
13. Set the desired Start and Interrupt signals for the process in the procedure
table.