MTS Series 793 Application - Manual (Page 356)

MTS MultiPurpose TestWare®
Digital Input Detector Process
Event Process Descriptions 356
General tab
For more information
See “How to set signal options” on page 353.
Action Specifies one of the following detector actions:
None The process ends without generating a message or performing an action.
Station Power
Off The process removes hydraulic power from the station. The test can be
resumed after you reset interlocks and reapply hydraulic power to the station.
Interlock The process triggers a hydraulic interlock and shuts down the hydraulic power
supply. The test can be resumed after you reset the interlock, reactivate
hydraulic power, and apply hydraulic power to the station.
Program
Interlock The process triggers a program interlock. The test can be resumed after you
reset the interlock.
Program Stop The process stops the test. This action functions the same as clicking the Stop
button on the Station Controls panel.
Program Hold The process suspends the test until you click the Run button on the Station
Controls panel. This action functions the same as clicking the Hold button on
the Station Controls panel.
Settings Tab (part 2 of 2)
I TEM D ESCRIPTION
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.