MTS Series 793 Application - Manual (Page 210)

MTS MultiPurpose TestWare®
Profile Process
Command Processes 210
Note Only one Profile process with manual compensation may run at a time.
Note Setpoint and Span controls (defined in the MPT Options Editor) must be
disabled while the manual compensation feature is running. You must
select Disable and Reset for both controls or MPT will generate an error
when the procedure is locked.
Adjusted values applied
to repeats
The values of the manual slider adjustments are normally reset when the process
is done. However, the manual adjustment values are temporarily stored during
the current session, and are automatically reapplied to repeats of the Profile
process. So once you adjust the Setpoint and Span sliders of an active profile
process, you can expect MPT to reapply your values to repeat instances of the
Profile process within the current run of the test procedure.
Adjusted values not
saved for recovery
Once the test procedure has been unlocked or reset, the manual adjustment values
are lost and are not restored as part of normal test procedure recovery. (Manual
adjustment values are not saved to the specimen.mps file.)
Setpoint and Span sliders
appear in the manual
compensation panel when
you lock the test
procedure. You can adjust
the values when the
Profile process is active.
You can adjust slider
parameters by double-
clicking the Setpoint and
Span labels on the manual
compensation panel.