Rockwell Automation 1771-QB Linear Pos. - Manual (Page 168)

Troubleshooting
Chapter 11
11Ć6
Figure 11.2
Troubleshooting Flowchart (Continued)
B
Check diagnostic
Programming
Error
?
word(s) to determine
the cause of the
programming error.
Faults
indicated by
2nd status
word(s)
?
Perform a
manual jog.
Jogs
OK
?
READY
bit set
?
Take appropriate
corrective action.
A
1. Check PLC program to
ensure that a parameter
block was sent.
2. Check parameter block
values.
1. Check for active stop or
reset commands.
2. ReĆcheck for errors in
status block.
3. Ensure that axis
integration has been
performed correctly.
NO
YES
NO
YES
YES
NO
NO
YES
5