Show bootvar – Dell PowerEdge VRTX User Manual
Page 150
150
Configuration & Image File Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Configuration_Image.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
speed 1000
exit
no lldp run
interface vlan 1
ip address 1.1.1.1 255.0.0.0
exit
line console
exec-timeout 0
exit
console#
show bootvar
Use the show bootvar EXEC mode command to display the active system
image file that was loaded by the device at startup, and to display the system
image file that will be loaded after rebooting the switch.
Syntax
show bootvar
show bootvar [unit
unit-id
]
Parameters
This command has no arguments or keywords.
Command Mode
User EXEC mode
Example
The following example displays the active system image file that was loaded
by the device at startup and the system image file that will be loaded after
rebooting the switch:
console# show bootvar
Image Filename Version Date Status
----- --------- --------- --------------------- -----------