Dell PowerEdge VRTX - Manual (Page 411)

Address Table Commands 411
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
For each Forwarding Data Base (FDB) mode, use different CLI commands to
configure static entries in the FDB, as described in the following table:
The following table describes the actual data that is written to the Forwarding
Data Base (FDB) as a function of the IGMP version that is used in the
network:
(*) Note that (*,G) cannot be written to the FDB if the mode is ipv4-src-
group. In that case, no new FDB entry is created, but the port is added to the
static (S,G) entries (if they exist) that belong to the requested group. It is
recommended to set the FDB mode to ipv4-group or mac-group for IGMP
version 2.
If an application on the device requests (*,G), the operating FDB mode is
changed to
ipv4-group.
Example
The following example configures the Multicast bridging mode as an mac-
group on VLAN 2.
console(config)# interface vlan 2
console(config-if)# bridge multicast mode mac-group
FDB Mode CLI Commands
mac-group bridge multicast address bridge multicast forbidden address
ipv4-group bridge multicast ip-address bridge multicast forbidden ip-
address s
ipv4-src-group bridge multicast source
group
bridge multicast forbidden source
group
FDB mode IGMP version 2 IGMP version 3
mac-group MAC group address MAC group address
ipv4-group IP group address IP group address
ipv4-src-group (*) IP source and group addresses