Dell PowerEdge VRTX - Manual (Page 699)

IPv6 Commands 699
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IPv6_Router.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
DAD is not supported on NBMA interfaces. The switch will enable DAD
automatically when the user change the type of the tunnel to manual if a
the parameter value bigger than 0.
• number of DAD attempts:—Number of consecutive neighbor solicitation
messages that are sent on the interface while duplicate address detection is
performed.
• vlan 1 is up/up—Indicates the interface status: administrative/operational.
• IPv6 is enabled, stalled, disabled (stalled and disabled are not shown in
sample output)—Indicates that IPv6 is enabled, stalled, or disabled on the
interface. If IPv6 is enabled, the interface is marked “enabled.” If duplicate
address detection processing identified the link-local address of the
interface as being a duplicate address, the processing of IPv6 packets is
disabled on the interface and the interface is marked “stalled.” If IPv6 is
not enabled, the interface is marked “disabled.”
• link-local address—Displays the link-local address assigned to the
interface.
• Global Unicast address(es):—Displays the global Unicast addresses
assigned to the interface. The type is manual or autoconfig.
• Joined group address(es):—Indicates the Multicast groups to which this
interface belongs.
• ICMP error messages—Specifies the minimum interval (in milliseconds)
between error messages sent on this interface.
• ICMP redirects—The state of Internet Control Message Protocol (ICMP)
IPv6 redirect messages on the interface (the sending of the messages is
enabled or disabled).
• number of DAD attempts:—Number of consecutive neighbor solicitation
messages that are sent on the interface while duplicate address detection is
performed.
• ND reachable time—Displays the neighbor discovery reachable time (in
milliseconds) assigned to this interface.
• ND advertised reachable time—Displays the neighbor discovery reachable
time (in milliseconds) advertised on this interface.
• ND advertised retransmit interval—Displays the neighbor discovery
retransmit interval (in milliseconds) advertised on this interface.