Dell PowerEdge VRTX - Manual (Page 719)

IP Routing Protocol-Independent Commands 719
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IP_Routing_MeS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: disabled
Codes: > - best, C - connected, S - static, I - ICMP
IP Routing Table - 5 entries
Code IP Route Distance/ Next Hop Last Time Outgoing
Metric IP Address Updated Interface
------ ------------------- ----------- --------------- ------------- ------------
S> 10.10.0.0/16 1/128 10.119.254.244 00:02:22 vlan2
S> 10.10.0.0/16 1/128 10.120.254.244 00:02:22 vlan3
S> 10.16.2.0/24 1/128 10.119.254.244 00:02:22 vlan2
C> 10.119.0.0/16 0/1 0.0.0.0 vlan2
C> 10.120.0.0/16 0/1 0.0.0.0 vlan3
Example 2. The following is sample output from the show ip route command
when IP Routing is enabled:
console# show ip route
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: enabled
Codes: > - best, C - connected, S - static
Codes: > - best, C - connected, S - static
IP Routing Table - 4 entries
Code IP Route Distance/ Next Hop Last Time Outgoing
Metric IP Address Updated Interface
------ ------------------- ----------- --------------- ------------- ------------
C> 10.159.0.0/16 0/1 0.0.0.0 vlan2
C> 10.170.0.0/16 0/1 0.0.0.0 vlan2
S> 10.175.0.0/16 1/1 10.119.254.240 vlan2
S> 10.180.0.0/16 1/1 10.119.254.240 vlan2
Example 3. In the following example, the logical AND operation is performed
on the address 10.16.0.0 and the mask 255.255.0.0, resulting in 10.16.0.0. On
each destination in the routing table the logical AND operation is also