Dell PowerEdge VRTX - Manual (Page 726)

726 ACL Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\ACL.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• icmp-type —Specifies an ICMP message type for filtering ICMP packets.
Enter a number or one of the following values: echo-reply, destination-
unreachable, source-quench, redirect, alternate-host-address, echo-
request, router-advertisement, router-solicitation, time-exceeded,
parameter-problem, timestamp, timestamp-reply, information-request,
information-reply, address-mask-request, address-mask-reply, traceroute,
datagram-conversion-error, mobile-host-redirect, mobile-registration-
request, mobile-registration-reply, domain-name-request, domain-name-
reply, skip, photuris. (Range: 0–255)
• icmp-code —Specifies an ICMP message code for filtering ICMP packets.
(Range: 0–255)
• igmp-type —IGMP packets can be filtered by IGMP message type. Enter a
number or one of the following values: host-query, host-report, dvmrp,
pim, cisco-trace, host-report-v2, host-leave-v2, host-report-v3. (Range:
0–255)
• destination-port —Specifies the UDP/TCP destination port. You can enter
range of ports by using hyphen. E.g. 20 - 21. For TCP enter a number or
one of the following values: bgp (179), chargen (19), daytime (13), discard
(9), domain (53), drip (3949), echo (7), finger (79), ftp (21), ftp-data (20),
gopher (70), hostname (42), irc (194), klogin (543), kshell (544), lpd
(515), nntp (119), pop2 (109), pop3 (110), smtp (25), sunrpc (1110, syslog
(514), tacacs-ds (49), talk (517), telnet (23), time (37), uucp (117), whois
(43), www (80). For UDP enter a number or one of the following values:
biff (512), bootpc (68), bootps (67), discard (9), dnsix (90), domain (53),
echo (7), mobile-ip (434), nameserver (42), netbios-dgm (138), netbios-ns
(137), on500-isakmp (4500), ntp (123), rip (520), snmp (161), snmptrap
(162), sunrpc (111), syslog (514), tacacs-ds (49), talk (517), tftp (69), time
(37), who (513), xdmcp (177).(Range: 0–65535).
• source-port —Specifies the UDP/TCP source port. Predefined port names
are defined in the destination-port parameter. (Range: 0–65535)
• match-all list-of-flags —List of TCP flags that should occur. If a flag should
be set, it is prefixed by “+”. If a flag should be unset, it is prefixed by “-”.
Available options are +urg, +ack, +psh, +rst, +syn, +fin, -urg, -ack, -psh,
-rst, -syn and -fin. The flags are concatenated to a one string. For example:
+fin-ack.
• time-range-name—Name of the time range that applies to this permit
statement. (Range: 1–32)