Dell PowerEdge VRTX - Manual (Page 508)

508 Spanning-Tree Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Spanning-Tree.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Parameters
• instance-id—Specifies the spanning tree instance ID. (Range: 1–15)
•
priority—Specifies the port priority. (Range: 0–240 in multiples of 16)
Default Configuration
The default port priority is 128.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the port priority of gi0/1 to 144.
console(config)# interface gi0/1
console(config-if)# spanning-tree mst 1 port-priority 144
spanning-tree mst cost
Use the spanning-tree mst cost Interface (Ethernet, Port Channel)
Configuration mode command to configure the path cost for MST
calculations. If a loop occurs, the spanning tree considers path cost when
selecting an interface to put in the Forwarding state. Use the no form of this
command to restore the default configuration.
Syntax
spanning-tree mst instance-id cost cost
no spanning-tree mst instance-id cost
Default Configuration
N/A