Dell PowerEdge VRTX - Manual (Page 791)

Quality of Service (QoS) Commands 791
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
qos trust (Interface)
Use the qos trust Interface Configuration (Ethernet, Port-channel) mode
command to enable port trust state while the system is in the basic QoS
mode. Use the no form of this command to disable the trust state on each
port.
Syntax
qos trust
no qos trust
Parameters
N/A
Default Configuration
Each port is enabled while the system is in basic mode.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example configures gi0/1 to the default trust state.
console(config)# interface gi0/1
console(config-if)# qos trust
qos cos
Use the qos cos Interface Configuration (Ethernet, Port-channel) mode
command to define the default CoS value of a port. Use the no form of this
command to restore the default configuration.
Syntax
qos cos default-cos
no qos cos