Dell PowerEdge VRTX User Manual
Page 182
182
SNMP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• md5—Specifies the HMAC-MD5-96 authentication level.
•
Sha—Specifies the HMAC-SHA-96 authentication level.
•
auth-password—Specifies the authentication password. Range: Up to 32
characters.
•
priv-password—Specifies the privacy password (The encryption algorithm
used is data encryption standard - DES). Range: Up to 64 characters.
Default Configuration
No group entry exists.
Command Mode
Global Configuration mode
User Guidelines
For SNMP v1 and v2, this command performs the same actions as snmp-
server community-group, except that snmp-server community-group
configures both v1 and v2 at the same time. With this command, you must
perform it once for v1 and once for v2.
When you enter the show running-config command, you do not see a line for
the SNMP user defined by this command. To see if this user has been added
to the configuration, type the show snmp user command.
A local SNMP EngineID must be defined in order to add SNMPv3 users to
the device (use the
command). For remote
hosts users a remote SNMP EngineID is also required (use the
command).
Changing or removing the value of snmpEngineID deletes the SNMPv3
users’ database.
The logical key of the command is username.
Configuring a remote host is required in order to send informs to that host,
because an inform is a trap that requires acknowledgement. A configured
remote host is also able to manage the device (besides getting the informs)
To configure a remote user, specify the IP address for the remote SNMP agent
of the device where the user resides. Also, before you configure remote users
for a particular agent, configure the SNMP engine ID, using the
command. The remote agent's SNMP engine ID is needed