Dell PowerEdge VRTX - Manual (Page 368)

368 Ethernet Configuration Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Ethernet.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
back-pressure
Use the back-pressure IInterface (Ethernet) Configuration mode command
to enable back pressure on a specific interface. Use the no form of this
command to disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Back-pressure cannot be enabled when EEE is enabled.
This command is not supported on 10G fiber ports.
Example
The following example enables back pressure on port gi0/1.
console(config)# interface gi0/ 1
console(config-if)# back-pressure
port jumbo-frame
Use the port jumbo-frame Global Configuration mode command to enable
jumbo frames on the device. Use the no form of this command to disable
jumbo frames.
Syntax
port jumbo-frame
no port jumbo-frame