Dell PowerEdge VRTX User Manual
Page 421
Address Table Commands
421
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
For each Forwarding Data Base (FDB) mode, use different CLI commands to
configure static entries for IPv6 Multicast addresses in the FDB, as described
in the following table:
The following table describes the actual data that is written to the Forwarding
Data Base (FDB) as a function of the MLD version that is used in the
network:
(*) Note that (*,G) cannot be written to the FDB if the mode is ip-src-group.
In that case, no new FDB entry is created, but the port is added to the (S,G)
entries (if they exist) that belong to the requested group.
If an application on the device requests (*,G), the operating FDB mode is
changed to ip-group.
You can execute the command before the VLAN is created.
Example
The following example configures the Multicast bridging mode as an ip-
group on VLAN 2.
console(config)# interface vlan 2
console(config-if)# bridge multicast ipv6 mode
ip-group
FDB Mode
CLI Commands
mac-group
ipv6-group
bridge multicast ipv6 ip-address bridge multicast ipv6 forbidden
ipv6-src-group
bridge multicast ipv6 forbidden
FDB mode
MLD version 1
MLD version 2
mac-group
MAC group address
MAC group address
ipv6-group
IPv6 group address
IPv6 group address
ipv6-src-group
(*)
IPv6 source and group addresses