Igmp commands, Ip igmp last-member-query-count, 32 igmp commands – Dell PowerEdge VRTX User Manual
Page 601
Template Last Updated - 2/7/2007
IGMP Commands
601
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
34
IGMP Commands
ip igmp last-member-query-count
To configure the Internet Group Management Protocol (IGMP) last member
query counter, use the ip igmp last-member-query-count command in
interface configuration mode. To restore the default value, use the no form of
this command.
Syntax
ip igmp last-member-query-count
count
no ip igmp last-member-query-count
Parameters
count—The number of times that group- or group-source-specific queries are
sent upon receipt of a message indicating a leave. (Range: 1–7)
Default Configuration
A value of IGMP Robustness variable.
Command Mode
Interface configuration
User Guidelines
Use the ip igmp robustness command to change the IGMP last member
query counter.
Example
The following example changes a value of the IGMP last member query
counter to 3:
interface vlan 1
ip igmp last-member-query-count 3