Dell PowerEdge VRTX - Manual (Page 174)

174 SNMP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to send an SNMP trap or inform.
Use the no snmp-server source-interface traps command to remove the
source interface for SNMP traps.
Use the no snmp-server source-interface informs command to remove the
source interface for SNMP informs.
Use the no snmp-server source-interface command to remove the source
interface for SNMP traps and informs.
Example
The following example configures the VLAN 10 as the source interface for
traps.
console(config)# snmp-server source-interface traps vlan 100
snmp-server source-interface-ipv6
To specify the interface from which a Simple Network Management Protocol
(SNMP) trap originates the informs or traps, use the snmp-server source-
interface command in Global Configuration mode. To returned to the
default, use the no form of this command.
Syntax
snmp-server source-interface-ipv6 {traps | informs} interface-id
no snmp-server source-interface-ipv6 [traps | informs]
Parameters
• traps—Specifies the SNMP traps interface.
•
informs—Specifies the SNMP traps informs.
• interface-id —Specifies the source interface.