Fluke Biomedical 2MF Index - Manual (Page 65)

Using Test Programs
Returning an Automatic Test Program to Default State
8
8-15
•
At the RUN screen, use + or - to display the program to be run, if it is not the
first program automatically displayed.
esl118.eps
2. To run the displayed program, press the softkey START.
esl119.eps
The program will prompt you as needed to press ADV to move from test to test.
3. When finished, the LCD screen displays the message “Program 2 Complete!” and
presents the option of printing the results (as well as the number of copies to print).
4. Press esc to return to the Run screen. Press esc again to return to the
Autosequences menu.
Returning an Automatic Test Program to Default State
You can return a modified (and saved) autosequence program to its default state, that is,
the way it was programmed at the factory, at any time.
1. From the Autosequences menu, press the DEFS softkey.
esl120.eps
A screen similar to the following displays the question “restore?” and the program
number:
esl121.eps