Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 144)

130 Operator’s Manual
I/O Configuration Type “B”
For type “B” configured controls, the operator may choose between three cut modes.
Automatic
Cutting in Automatic mode allows the part to be cut with all preheat and cutting processes to be
performed by the control.
Manual
Cutting in Manual mode allows the part to be cut with the operator manually preheating and starting
the cut process using the machine’s cutting controls.
Test Run
When Test Run is selected, the cutting machine will move through the motions of the part selected
without cutting.