Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 210)

196 Operator’s Manual
Traverses are automatically determined between pierce points and need not be entered on the
CAD drawing.
The following is a basic Bolt Hole Rectangle with the Lead-in and Lead-out for the rectangle as
part of the top and side line segments. The numbers indicate the order of the pierces and the “+”
sign indicates a Counter-Clockwise rotation for the circles.
Example:
+ +
+ +
1 2
3 4
5
If the Lead-in and Lead-out were made up as additional line segments added to the top and side
line segments, additional text would be required to indicate which direction the next line segment
should take as part of the part program.