Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 158)

144 Operator’s Manual
CBH
Pressing the CBH softkey causes the automated homing procedure to be executed. This
procedure generally produces machine motion in the CBH axis, depending on the homing
parameters set in the Setups.
THC
Pressing the THC softkey causes the automated homing procedure for the Sensor™ THC to be
executed. This procedure generally produces machine motion in the THC axis, depending on the
homing parameters set in the Setups.
Tilt
Pressing the Tilt softkey causes the automated homing procedure for the Tilt Axis to be executed.
Rotate
Pressing the Rotate softkey causes the automated homing procedure for the Rotate Axis to be
executed.
Note: If Tilt and Rotate Axes are enabled, the following window will appear to allow access to the
Tilt/ Rotate or other axes.
Selecting “Yes” will access Homing for the Tilt and Rotate Axes. Selecting “No will access the
Homing functions for the other axes,
All
Pressing the All softkey causes the automated homing procedure to be executed. This procedure
generally produces machine motion in one or more axes, depending on the homing parameters
set in the Setups.
Go To Home Position
Pressing one of the four Go To Home Position softkeys causes the Transverse and Rail axes to
move to the predefined position set in the corresponding edit window. The Go To Positions are
absolute and require that an automated home procedure be executed previously.