Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 45)

Section 3: Setups 31
I/O Configuration Type “B”
I/O Configuration Type “B” (Timing Diagram)
Press the Space Key to view the timing diagram from Setups.
Ignition Time
Specifies the length of time that the oxy fuel igniter is held on at each ignition of the flame.
Low Preheat
For those cutting systems that are equipped with a Low Preheat feature, this parameter allows the
operator to input a timing delay to activate the Low Preheat output prior to the High Preheat.