Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 90)

76 Operator’s Manual
Save to Disk
The following screen is used to save a part to a diskette or the hard drive. Once all the parameters
below are set, press ENTER on the keyboard to save the part.
Save to
The Save to list selects whether you save to the diskette or to a directory on the hard disk. To select
a different directory, use the
↑ and ↓ keys on the keyboard. To add a new directory, use the + key on
the keyboard. To remove a directory, use the - key on the keyboard.
File name/Diskette file name
The File name is the name that you are giving the file you are loading on the disk.
Save Original Text
Selecting the Save Original Text option will save the part to disk in its original programming format.
Note: This selection is not available if saving to the diskette from the hard drive.
Save from
The Save from list selects whether you save from the current part or from a directory on the hard disk.
To select a different directory, use the
↑ and ↓ keys on the keyboard. To add a new directory, use
the + key on the keyboard. To remove a directory, use the - key on the keyboard. Note: This
selection is only available if saving to the diskette from the hard drive.
Files
The Files list box is a list of all the files that are in the Load from directory that can be loaded from the
disk. To scroll through different files, use the
↑, ↓, PAGE UP and PAGE DOWN keys on the
keyboard. To remove a file, use the - key on the keyboard. To select multiple files to load, highlight
the first file selection, then use the
↑ and ↓ keys while pressing the shift key to highlight the remaining