Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 53)

Section 3: Setups 39
Cut Control Used for Marking
This parameter is used to determine if the Cut Control output is to be used for activating the Marking
tool. If set to no, the Marking Output would be used.
Marker Down/Up With Each Marker On/Off
The Marker Down/Up With Each Marker On/Off will command the send the appropriate Up/Down
Output commands at each Mark On/ Off.
Arc On Feedback
Specifies whether an arc-on signal from a plasma marking system to the control is used. With Arc On
Feedback ON, the control waits for Cut/Mark Sense input to activate before initiating machine motion.
Partial Raise
Enabling the Partial Raise feature will execute a tool raise at the end of the Mark within a nest for the
time specified in the Partial Up Time parameter. Full raise will be executed at the end of the final
Mark segment.
Down On During Mark
Turning on the Down On During Mark feature forces the torch down output to remain on throughout
the Marking process. This is advantageous for pneumatic style torch lifters that require a constant
output.
Down On Between Marks
Turning on the Down On Between Marks feature forces the Torch Down Output to remain on while
traversing between marking segments.
Note: Please refer to the Program Codes section of this guide for information on the Marker Font
Generator feature.