Hypertherm HTA Rev 6.00 Operators Manual User Manual
Page 61
Section 4: Shape Manager
47
Section 4: Shape Manager
Shape Library
The control contains a built-in Shape Library with more than 53 commonly used shapes. These
shapes are parametric. Parametric shapes are shapes that are not fixed in size or geometry.
The Shape Library consists of more than 53 shapes as shown below. The screen is defined in colors,
from the easiest (green) to the hardest (black).
Selecting a Simple Shape
After pressing Shape Library from the Main Menu, the control display shows the Shape Library as
shown above. At this time, simply use the arrow keys to navigate to the desired shape you wish to
cut and press ENTER. If the selection is incorrect, press CANCEL and re-select the shape.
At this point, the shape is displayed with the default parameters, or the parameters from the last edit
session of this shape. Detailed information on the available shapes can be found in the following
section.