Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 71)

Section 4: Shape Manager 57
Add Part
Pressing the Add Part softkey accesses the screen, which allows the user to select a part program
from a selected source.
Remove Part
This softkey is used to remove the selected part from the nest parts list.
Cut Earlier
Pressing the Cut Earlier softkey will move the selected part program to an earlier position in the part
cut list. The sequence in which the parts are cut are changed, but not the selected part location in the
nest.
Cut Later
Pressing the Cut Later softkey will move the selected part program to a later position in the part cut
list. The sequence in which the parts are cut are changed, but not the selected part location in the
nest.
View Sheet / View Part
View Sheet allows the viewing of a part as it would appear on the plate. After pressing the View Sheet
softkey, the display window zooms out to show the part in relationship to the entire plate.
After zooming out, the display can be zoomed in again by pressing the + key, which causes horizontal
and vertical scroll bars to be displayed. Pressing the - key will zoom back out.
More information on use of this feature is provided in the Manual cutting section.
Arrow Key ( Distance )
The Arrow Key allows the user to select one of five different preset move distances when the arrow
keys are pressed to locate parts in the nest. These five distances are definable and are selected in
the Nester™ Setup screen.
Setup
Pressing the Setup softkey accesses the Nester™ Setup screen for configuring the variable
parameters when using Nester™.
Done
The Done softkey is used to end the Nesting program, return to the Main Cut Screen and temporarily
save the nested program as the current part. At this point, the part can be cut or saved to disk
through the Shape Manager. Pressing the cancel key will return the user to the Main Cut Screen
without saving the nested program.