Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 156)

142 Operator’s Manual
Manual Offset
Manual Offset is useful for cutting tables that have a laser alignment tool attached and allows you
to use your laser alignment tool for aligning a part to a plate. The offset will stay in place until it is
turned off from this screen or a part is cut in either Oxy-Fuel or Plasma cut mode.
The user may select the following offsets:
User Defined – Uses the selected X / Y Offset distance.
Laser pointer to Plasma 1 – Offset 10
Laser pointer to Plasma 2 – Offset 11
Laser pointer to Oxy Fuel – Offset 12
Press the purple or blue shift keys to edit the Manual Offset Parameters.
Adjust Dual Gantry Skew
Allows the operator to manually realign the Dual Gantry Axis using the directional arrow (
↑ and ↓
) keys.